Management of EX90, registerd to CUCM

[stijnlaureys]

Hi,

I've got an EX90 running TE6.0 registered to cucm (8.6).

The cucm is connected with TMS so i can add them and schedule conferences with the cucm registered systems.

But i'm looking for a way to manage the EX90.

With tms, templates can be pushed with all possible settings.

How can this be done when a system is registered on a cucm?

For example: i want to push the facility service settings.

Is this perhaps a limitation?

Regards

Stijn

[Kjetil Ree]

Hi,

TMS does not push settings to Cisco Unified CM registered endpoints (with the exception of the feedback address TMS uses for call monitoring).

This is a deliberate decision, so I'm not sure if I would describe it as a "limitation".

Best regards,

Kjetil

[stijnlaureys]

I know it's not supported.

I'm looking for a way via CUCM. Can i push settings like the facility service?

Or is there a limit which can be pushed via CUCM?