09-30-2005 07:59 AM - edited 03-17-2019 08:31 PM
How do I 'mark-down' VC calls from AF41 (COS 4) on the LAN to AF31 (COS 3) for the WAN provider? (The WAN provider is looking at AF31 and designating that as Video traffic when it connects to their network). Do I do this on the router or on the switches? Are there any sample configs available?
Thks
Jay
09-30-2005 09:09 PM
hi
if your switch is already marking this VC calls as COS 4 and sending it to your router then you can define a class map matching all the cos4 marked traffic and set cos 3 under the policy map while remarking.
Place the service policy on the outgoing interface facing your SP side...
just try this out and revert back how it goes...
regds
10-02-2005 07:03 AM
Would you have a sample of how do this?
10-02-2005 07:52 PM
Hi
do find some sample config lines which can help u out..
!
class-map match-any test
match cos 4
!
policy-map test
class test
set dscp af31
!
Apply this policy map under your wan interface connected to the remote site.
apply it in the outbound direction...
!
interface serial 1/0
service-policy output test
!
hope this helps ...
regds
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide