New thread to old question

[ccthompson]

Have call manager express. Need to find a way to ring both an analog phone and voip phone at the same time.

I have setup a dial peer as follows:

dial-peer voice 7399 voip

destination-pattern 7399

modem passthrough nse codec g711ulaw

voice-class h323 1

session target ipv4:192.168.1.1

codec g711ulaw

fax rate disable

Ephone-dn setup like:

ephone-dn 1 dual-line

number 7399

ephone 1

button 1:1

Any ideas how to make these both ring at the same time? Only the ip phone rings.

[paolo bevilacqua]

where is the analog phone ? Do you have an FXS port in the router, or ata ?

[ccthompson]

Using an ATA

[paolo bevilacqua]

Upgrade ATA to latest SCCP code. Configure as ephone and assign the same DN "button".

If you do not have CCO download access for ATA image, get a maintenance contract or email me.

[ccthompson]

Im pretty sure i have the latest ATA image. But how do i configure it as an ephone?

[paolo bevilacqua]

Which image do you have? You need a SCCP image, not H.323.

Then configure just like two ephones, each with mac, type ATA and button.