09-14-2019 08:54 AM
Fix:
Log in to the codec.
(you need the IP address, username / password)
Go to:
Setup > Configuration > Peripherals > (in the “Profile” area, set “Cameras” to 0.
Press “Save” on the top right of the screen.
Message went away.
09-15-2019 06:26 PM
Yes, that is correct, and the same as I suggested here: https://community.cisco.com/t5/telepresence-and-video/message-camera-not-conected/m-p/3417280#M94277 that you marked as Helpful, as well as the answer provided in this thread: https://community.cisco.com/t5/telepresence-and-video/cisco-sx80-removing-no-camera-connected-warning-from-osd/m-p/2786574 which you also marked as Helpful.
Note: this also works for other models of codec that run the CE software image (ie Room Kit Series) as well as the SX80.
Please remember to mark helpful responses and to set your question as answered if appropriate.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide
Log in to Community