03-04-2014 03:54 AM - edited 03-18-2019 02:41 AM
Hi everybody,
I have created a little script, who push the wallpaper via winscp on to the codec.
Path is /users/posters witht the correct naming.
But the endpoint shows me a black screen, the xconfig parameter is set to custom.
So everything is correct, but black.
If I do a call and end them immediatly the new wallpaper will be displayed.
This looks like there is a reload of the wall paper missing.
How can I do that at the cli, without a reboot of the system?
regards Jens
Solved! Go to Solution.
03-04-2014 05:24 AM
What happens if you issue the wallpaper command after you upload it, does it refresh then?
xConfiguration Video Wallpaper: Custom
Note: command might be a little off, typing from memory.
Sent from Cisco Technical Support iPhone App
03-04-2014 05:24 AM
What happens if you issue the wallpaper command after you upload it, does it refresh then?
xConfiguration Video Wallpaper: Custom
Note: command might be a little off, typing from memory.
Sent from Cisco Technical Support iPhone App
03-04-2014 05:34 AM
Ok this works not really, but should be a workaroud.
1.xconfiguration Video Wallpaper: Summersky
2.xconfiguration Video Wallpaper: Custom
You must switch to another wallpaper and back to custom.
It is not the answere I was looking for, but ok.
03-04-2014 06:15 AM
What about not switching to the custom wallpaper until it's loaded?
Sent from Cisco Technical Support iPhone App
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide