SIP Gateway Configuration

[hardiklodhia]

Hello All,

I have 1 SIP application which works on SIP and recieves and places call. I am using cisco 2811 router as gateway and has E1 pri connection for placing and receiving calls. My challenge is what are configuration commands do i need to configure cisco Gateway so that any call comes to e1 should redirected to that sip application.

how router recognize that application.

Thanks in advance.

[paolo bevilacqua]

For basic use, only dial-peer configuration and few entries under serial interface. You may need some translation-profile and rule however.

If you never used cisco before, begin from there:

http://www.cisco.com/en/US/tech/tk652/tk90/technologies_tech_note09186a0080147524.shtml