Good day,
I am urgently seeking a xcommand that will open a newly added panel & page on the cisco touch. We want to simulate a button press to bring it up for user feedback at the end of the meeting or call.
One might be able to do this fromthe macros section but the SX10 does not support Macros.
I can currently close the custom page by using:
-----------------------------------------------
xcommand UserInterface Extensions panel Close
-----------------------------------------------
I have tried this command to open the panel/page:
- I do get an OK reply but the page does not actually pop up..
-----------------------------------------------
xcommand UserInterface Extensions panel Clicked PanelId: "test"
OK
*r PanelClickedResult (status=OK):
** end
-----------------------------------------------
Can someone please advise if this is possible
Kind Regards