SX20 calling SIP

[Syahrir Mohamed Yatim]

Hi

I would like to know, is it possible to call from SX20 to other endpoint with adress (100000@xxx.xxx.xxx.xxx) without register to VCS

Meaning call as a standalone device to other endpoint.

If so, could you guide me.

Best Regards

Syahrir Mohamed Yatim

[Martin Koch · Accepted solution]

Why do you want to do this? If its in between cisco/tandberg/3rd party

equipment and its capable of using h323 I would prefer that.

Stand alone sip will most likely not work properly behind NAT.

For that I strongly recomend to use a VCS-E

Besides that from factory default it would just be to dial what you wrote.

Maybe you want to set the default call protocol to sip and also play around

with the DefaultTransport setting for sip, but you can just dial the ip address.

Please remember to rate helpful responses and identify helpful or correct answers.