SX80 loses settings after power-of

[GeertMeyns]

I have 2 identical SX80 systems. One of them loses H323 and Network Services settings after a power of.

Any Ideas?

Software version:ce 8.1.1 Final a8488ee 2016-04-20

[Enrique Alberto Fallas Rojas]

Are these devices registered to CUCM?

What network services are getting lost?

I have seen a similar behavior with device provisioned by CUCM. By default CUCM turns off H323 settings on the TelePresence endpoints if it is in charge of their provisioning.

Generally to get around of this behavior, you will use a startup script on the endpoint to enable the services upon boot up.