Unable to limit bandwidth between two SX-20 units

[Kelvin Machakaire]

Hello!

I have got 2 SX-20 units connecting directly to one another using IP addresses h.323. I want to limit bandwidth between the 2 units at 768kbps.

So I have manually done it as follows:

Settings > Call settings > Default call rate: 768kbps

Problem is that even when I have done this setting on both ends, I still get the call running at 1920kbps.

What could be the problem and whats the remedy?

I look forward to your help.

[Dharmesh Nandoria]

Hi,

Please try following commnad from ssh .

xcommand Dial Number: XXXXXXX Protocol: h323 CallRate: 768 CallType: video

Call will be connect on 768 .

Also check

xConfiguration Conference 1 DefaultCall Rate:768

In you case  I suspect you are using redial function from call history and previous call was connected on 1920 and it is taking same bandwidth for call.

Kind regards,

Dharmmesh

[Kelvin Machakaire]

Thank you Dhamesh

Just as you mentioned I was placing calls from the call list using a previous call that had connected at a speed of 1920.

Now everything is ok.