Location of CUCM and Expressway Guide?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-09-2016 02:37 AM - edited 03-18-2019 06:14 AM
Hi Folks,
I have a customer who has ordered some MX300G2 and SX20's, along with IP Phones, WebEx CMR, CUCM and Expressway C/E.
Obviously we want to use the Expressway C/E for video calls/firewall traversal. Can anyone point me in the right direction for the correct guide? All the kind of guides I see appear to have VCS as the control of all or some of the endpoints registered to a VCS which isnt going to be the case in this deployment. Expressway is only for firewall traversal and all control is with the CUCM.
Many thanks for any helop with this.
Phil
- Labels:
-
Room Endpoints

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-09-2016 04:35 AM
Cisco Expressway-E and Expressway-C - Basic Configuration and Deployment Guide:
Cisco Expressway SIP Trunks to CUCM: http://www.cisco.com/c/dam/en/us/td/docs/voice_ip_comm/expressway/config_guide/X8-8/Cisco-Expressway-SIP-Trunk-to-Unified-CM-Deployment-Guide-CUCM-8-9-10-11-and-X8-8.pdf
/jens
Please rate replies and mark question(s) as "answered" if applicable/

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-09-2016 06:51 AM
In addition to the guides Jens provided, here are some more:
For registering endpoints from outside your firewall to CUCM - Mobile and Remote Access via Cisco Expressway Deployment Guide (X8.8)
CMR Cloud Enterprise Deployment Guide (WBS31).
Also, here are the remaining Expressway Series Configirstion Guides.
