TANDBERG UNIT III NTSC camera cable pinout

[Chet Cronin]

ALCON,

Does anyone have a reference document that describes the cable pinout and the cable part number for the old TTC-6 not TTC-7 (MXP6000) codec connection to the TANDBERG UNIT III NTSC (analog) camera???? 

Any assistance would be appreciated.

VR

Chet

[Steve Deslandes · Accepted solution]

Hello Chet,

Here is a link to get the Tandberg MXP user guide

http://www.cisco.com/c/dam/en/us/td/docs/telepresence/endpoint/mxp-series/f8/administration_guide/tandberg_mxp_administrator_guide_f80_august2010.pdf

On page 262, you will see the output pinouts from the 6000MXP codec and page 302 gives you the input pinout on the Camera Wave2.

Hope this helps

Steve