BE4000 insufficient dsp issue

[Vinod.s]

Guys,

I am getting insufficient dsp resource in be 4k portal , i have installed pvdm4- 64 on mo and pvdm4-32 on nim card.

Any help to mitigate this.

How to check pvdm status of be4k , from ssh i can only see nim pvdm status.

[Chris Deren]

Post your "show run" and "show dspfarm all" 

[Vinod.s]

This is not normal router where yiu get show run or dspfarm....its be4000

[Vinod.s]

I am getting this option only... attached

[Chris Deren]

Be4k is build on ISR 4K and I believe you can still get the output of the show commands.

[Vinod.s]

Its having limited feature ...if this is possible then can you guide me...so that i can troubleshoot furthrr...

[Jaime Valencia]

No, you can't, the CLI is locked down. It's the equivalent of the Linux on CUCM, you only get a handful of pre-configured commands and not full access. I believe there's also an equivalent of root access to get the normal IOS interface if TAC needs it. From what I know, there's only a handful of commands you can run, and they're mostly there for troubleshooting.

OP, your best option is to call TAC for this.

[Vinod.s]

You are correct... Even route patterns are also locked.