09-15-2005 01:10 PM - edited 03-18-2019 05:04 PM
We are experiencing caller getting cut off while leaving a message. The system cut them off before the complte their message. Is their someway to turn off the message pause tigger. I know if a caller pauses to long it will cut you off.
09-15-2005 02:24 PM
Make sure also to check the lengh or time how much message they can leave.
Increase this time and see if that fixs the problem
09-16-2005 05:35 AM
It's not a time limit issue
09-16-2005 07:16 AM
You can adjust the long and short timeouts - by default on a short message (one less than 10 seconds) a pause of 2 seconds will cause us to stop recording. On a long message (one more than 10 seconds) a pause of 3 seconds will cause us to stop. Both these values can be adjusted on the "Recordings" page of the Configuration section in the SA. I'd adjust with caution - if you crank those times out too far callers will have to wait that long when they stop speaking if they don't know to hit a key to terminate recording (most do but some folks prefer to wait) - I'd definitely not go out more than 5 seconds. If you have callers routinely pausing for 5 seconds and expecting the reocording to continue, I'd be a bit suprised...
09-19-2005 02:19 PM
I am running Unity 4.0(5) (no SR), and am experiencing an issue where the caller's message to the subscriber gets cutoff at 30 seconds. The class of service associated to the template is set for 180 seconds. Ideas?
09-16-2005 07:18 AM
There are two types of cutoffs. One is where Unity stops recording and offers the After Recording menu options. If you hear this then the cutoff may be due to silence detection or max recording length or something like that. The other type is where the phone call is dropped entirely. This typically means Unity has recieved some sort of disconnect event from the phone system. For this later type, you'll need to drill down a bit to determine where the disconnect event originates.
-Eric
09-19-2005 05:27 PM
Is this problem happening to ALL subscribers and are the messages ALWAYS 30 seconds long (not 29 secs, not 31 secs)?
If the answer is yes to the above, open Unity -> Licensing, and make sure that Message Recording Full Length is licensed.
09-20-2005 07:19 AM
Its happening at different time scales ie. 20 secs, 1 min, 2 min, etc..It mseems to be more of a low volume issue.
09-20-2005 05:30 PM
What is this integrated with? If you are using CCM, then what kind of gateways and voice cards?
09-21-2005 05:07 AM
Avaya G3r V11
09-21-2005 06:26 PM
It's possible that you are either getting disconnects due to low volume or disconnect tone.
Go through this doc Cisco Unity Tone Definitions and Learn Tones
http://www.cisco.com/en/US/products/sw/voicesw/ps2237/products_tech_note09186a0080093c1e.shtml
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide