09-29-2006 03:09 AM - edited 03-18-2019 06:24 PM
Hello
I have a problem deploying aa service on my ccme. I can't find good instructions about installing it.
my ccme is connected to PBX via fxo, and all configuration examples are with digital connection. Like this -
dial-peer voice 1000 pots
service aa
incoming called-number 8005550100
port 1/0:23
I've download tcl script and extracted it to flash memory, could you please list minimum commands that must be in my configuration for aa to answer the call.
Thank you in advance
04-07-2008 12:02 AM
Hi,
Have you been able to fix this problem? I presently have a similar situation with my AA service on CME with fxo ports.
Any body in the forum with a fix?
Regards,
04-07-2008 05:09 AM
What problem do you have exactly ?
04-07-2008 06:07 AM
The exact problem as explained in the original post. I have a CME and have enabled AA but the AA tcl script does not kick in so I do not hear the welcome prompt and other menu. I'm using vic2-4fxo is pick the call.
Is it that AA cannot work with the analogue FXO except when you a CUE to direct the incoming calling to the inbuilt AA which has a voip dial-peer?
Regards,
Kayode
04-07-2008 09:16 AM
B-ACD/AA can work with any type of line.
You need a DP voip with "incoming called-number XXX" where XXX is the same than in "connection plar XXX".
After that you debug the script itself with "debug voice application script" and "term mon".
Hope this helps, please rate post if it does!
04-07-2008 09:27 AM
Thanks but I've actually done all of these without success. Do you have a useful link? Which debug command can I run to verify the call progress apart from the debug voice application all?
Regards,
04-07-2008 09:32 AM
The main document is at:
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/bacd/configuration/guide/40bacd.html
Note, if "debug voice application script" produces no output, your DP config is wrong.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide