Cisco Jabber 12.6

[Drewmusonza2857]

Hello, I am trying to auto populate the advanced settings during installation, mainly these two areas..Select your account type: Cisco Communication Manager 9 or later and Use the following Server: . see image attached

i tried something like this, but it did not work: msiexec /i ciscojabber.msi  /quiet clear=1 Authenticator=CUCM  TFTP=mycompany.com

 msiexe command did not work also am not sure which xml file i can update to enter these setting

[Jaime Valencia · Accepted solution]

If you want to use Jabber in phone only mode there is no need to use any switches, configure your SRVs, do not enable the user for IM&P, and just configure the CSF device and associate it.