CME Question on 2 different PRI DID ranges

[ahrao]

Hello there,

I have a Cisco 2921 CME Router.  It has 2 Numbers MFT Cards (1 Port each).  I have terminated 2 PRI lines on each of the card.

On card one I have DID range 41292400 to 41292499 and my extensions are 2400 to 2499 and outgoing calls get routed through the serial 0/0/0:15

On the new card I want to configure the other DID range 41292800 to 41292899, with extensions 2800 to 2899, can any body let me know how to route the

calls from extensions 2800 to 2899 through the new card ie serial 0/0/1:15 and it should show up the new DID range whenever the user calls the PSTN.  Should I use COR to control this and if yes, how.

A quick reply appreciated.and thanked.

- Rao

[r.pennington]

I would think COR would do that for you.

Create the COR lists with a to groups for the, one for each PRI. Create two outbound dial peers one for port 0 and the other for 1 and apply a COR list to each. Then apply the relevant COR list to the ephone for the extensions, so only the phone you want has access to a particular outbound dial peer and therefore the trunk.

[ahrao]

Thank you so much, I shall work on this, it would be great if you could

give me a sample.

- Rao

[haithamnet]

I think this isn't the right place for this post (https://supportforums.cisco.com/index.jspa) .. however, this is the sample you requested :

dial-peer cor custom

name PRI1

name PRI2

dial-peer cor list isdn_pri1

member PRI1

dial-peer cor list isdn_pri2

member PRI2

ephone-dn  1  dual-line

number 2401

corlist incoming isdn_pri1

ephone-dn  2  dual-line

number 2801

corlist incoming isdn_pri2

dial-peer voice 1 pots

corlist outgoing isdn_pri1

destination-pattern 4.......

port 0/0/0:15

forward-digits all

dial-peer voice 2 pots

corlist outgoing isdn_pri2

destination-pattern 4.......

port 0/0/1:15

forward-digits all

Hope this helps

[ahrao]

Hey,

Thank you so much, it now works.

- Rao

[yixiu0317]

I am just wondering if this will work

dial-peer voice 1 pots

answer-address 24..

port 0/0/0:15

forward-digits all

dial-peer voice 2 pots

answer-address 28..

port 0/0/1:15

forward-digits all

[ahrao]

Hey,

Thank you so much, it now works.

- Rao