Config CUCM and CUBE

[blive56133]

Hi. I need help with configuration

Call for number 444-444 comes to CUCM1. It is translated into 555-111 and send to CUBE1. CUBE1 and CUCM1 use MGCP.

CUCM1 uses CUBE1 as MTP and signals CUCM2 that a call is coming. Call signaling is done via CUBE1 and CUBE2 both configured as MTP. Media flow through is being used.

Call never goes out to PSTN, it traverses 2 private networks connected through VPN tunnel

I need to configure CUCM1 and CUBE1

CUCM1 part

a) I need to create translation pattern and in called party transformations I set 555-555

b) create route pattern 555-555. Here I have to point it to Gateway/Route list. Do I use existing T1/E1 ports created for mgcp connection? Or do I create new trunk between CUCM1 and CUBE1

What do I need for the CUBE1? How do I configure it?

[Manish Gogna]

I am not sure why MGCP is being used here. You can make a SIP trunk from CUCM1 to CUBE1 and same between CUCM2 and CUBE2. In the route pattern, point to the SIP trunk for CUBE. CUBE / SIP gateway  will require voip dial peers to point to cucm and to other CUBE.

Manish

[Jaime Valencia]

It appears you deleted you other post on the same, so here's the reply again.

As Manish points out, which I also did, the fact you mention MGCP to control CUBE, is something that makes no sense.

That indicates you don't know how CUBE (or MGCP) works, and I as I mentioned, if you don't know exactly what you have configured, and how to configure what you need to have, chances are you'll break something else.

As to how to configure CUBE:

http://lmgtfy.com/?q=cube+configuration

As I recommended, you should really consider hiring a Cisco partner/consultant, to do this for you.