01-01-2010 02:40 AM - edited 03-19-2019 12:13 AM
Hello, im getting ready to take the CIPT I exam and i installed a CUCM 6.0 on a virtual machine, but i have no clue hot to get to the GUI from the CLI,
I can ping my virtula machine from the host, but i cant access throug the brownser either.
And the book that im following " Implementing Cisco Unified Communications Manager Part 1 CIPT1 Authorized Self Study Guide" doesnt say anything about it.
Can anybody help me ?
Thanks in advance.
Cesar
01-01-2010 01:12 PM
Make sure Tomcat is running, try restarting the service.
Open a web browser and type:
HTH
java
If this helps, please rate
www.cisco.com/go/pdihelpdesk
01-01-2010 11:13 PM
That wasnt the problem but it put me on the correct direction, all the services are stoped so im doing a new installation, i was using 30 gb of hard disk i readed that i need 74 is that right?.
Id like to rate, but i cant see how with that link.
thanks
Cesar
01-02-2010 01:37 AM
Its ok now, i had the proxy enabled all this time, but thanks anyway
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide