02-08-2016 12:13 AM - edited 03-19-2019 10:42 AM
Hi,
Hope you all are doing well,
well I have an issue on my 2801 CME in initialization the CUE module, before the module was working but somehow unfortunately I have formatted the flash card by using flash card reader on windows 7 on fat32 filesystem, now I have go through some threads and came to know that CUE module uses Linux filesystem, now can anyone help me in initializing the CUE module following are the messages i received when i retested it. i will be very grateful for you assistance.
------------------------------------------------------------------------------------------------------------------------------------
Router#service-module service-Engine 0/1 reset
Use reset only to recover from shutdown or failed state
Warning: May lose data on the the NVRAM, nonvolatile file system or unsaved configuration!
Do you want to reset?[confirm]
Trying to reload Service Module Service-Engine0/1.
Router#service-module service-Engine 0/1 sess
Router#service-module service-Engine 0/1 session
Trying 10.0.0.100, 2130 ... Open
256 MB SDRAM detected
BIOS Version: Cisco SE-AIM 01.02
BIOS Build date: 08/14/03
System Now Booting ...[BOOT-ASM]
Please enter '***' to change boot configuration: Found disk 0
found 1 drives
root cmd : root (hd0,0)
Filesystem type unknown, partition type 0xb
kf: a1 : /bzImage root=/dev/hda1 ro plat=aim
kf: a2 : /bzImage root=/dev/hda1 ro plat=aim
in grub_open: /bzImage root=/dev/hda1 ro plat=aim
kernel_func: kt: 0
Unable to load image
in boot func: kt: 0
Unable to boot imageÿ
Initializing memory. Please wait. ... 256 MB SDRAM detected
BIOS Version: Cisco SE-AIM 01.02
BIOS Build date: 08/14/03
System Now Booting ...[BOOT-ASM]
Please enter '***' to change boot configuration: Found disk 0
found 1 drives
root cmd : root (hd0,0)
Filesystem type unknown, partition type 0xb
kf: a1 : /bzImage root=/dev/hda1 ro plat=aim
kf: a2 : /bzImage root=/dev/hda1 ro plat=aim
in grub_open: /bzImage root=/dev/hda1 ro plat=aim
kernel_func: kt: 0
Unable to load image
in boot func: kt: 0
Unable to boot imageÿ
note: these messages continued unless I disconnect the session
02-13-2016 05:57 PM
Hi,
I had the same issue! Look here maybe it's helpful!
--> https://supportforums.cisco.com/discussion/12913606/cue-aim-unable-boot-image#comment-11152571
Cheers
Markus
02-14-2016 11:11 PM
Hi Markus,
Thanks for the reply, I will let you know after following the process.
Regards,
Ahmed
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide