03-27-2012 11:55 AM - edited 03-19-2019 04:40 AM
I am running a UC520 with the CME 7.0 code. Currently I am stuck with CME waiting for IOS to register its IP address. I have tried changing boot options but am confused why it will not allow me to get past this point. I can ping out of the devices to the network so to my knowledge my network connections are not the problem.
Any ideas?
03-27-2012 05:50 PM
That happens whe router is not coinfigured correctly, under service-module and host route to module.
03-27-2012 07:24 PM
Hi,
Was it working before?
Give following command
Service-module integrated-service-engine 0/0 shut
and then restart the router.
Regards
Ronak Patel
Please rate helpful posts.
03-28-2012 06:29 AM
The IP address of the service module is assigned in the CME configuration. During bootup, the module uses the SCP protocol to obtain the IP address from the CME router. So take a look to see if you have a "service-module ip address a.b.c.d ..." assigned and the interface is not shut down. Otherwise, do a "show run interface service-module x/y" on the CME and post it.
01-21-2013 09:23 AM
were anyone for you guys able to solve this . having the same issue with a uc650
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide