02-18-2018 11:58 PM - edited 03-19-2019 01:09 PM
Hi ,
I'm looking for a way to work with e&m card on voice gateway 2900 when the VG is in srst mode . so when I'm dialing to number from out side and he is getting to the VG with the E1 card that he have on him it will pass to the E&M card (on the same VG). can it happen that scenario ?
can we buy E&M card ? (EOL,EOS...)
Solved! Go to Solution.
02-20-2018 09:28 AM
02-20-2018 09:48 AM
02-20-2018 07:37 AM
02-20-2018 08:44 AM
Thank you for your response. This is about connecting to announcement
system. In the event of a failure to connect the cucm we will still be able to make a public announcement using the same E&M card . so in a daily working we will send to the E&M card calls that go to the announcement system and when we in srst mode we will call through telco and retch to the same router\srst that the e&m card connect on him .
02-20-2018 08:55 AM
02-20-2018 09:19 AM
Yes it is mgcp . so we can configure that to work with that scenario ?
02-20-2018 09:28 AM
02-20-2018 09:33 AM
I am planning to purchase one E&M card and do all the test that need to be done . after that I will going to purchase 20 E&M card on all my 2900 routers .
02-20-2018 09:48 AM
02-20-2018 10:00 AM
Yes i know.
Thanks for your help.
07-24-2018 10:27 PM - edited 07-24-2018 10:28 PM
Hi,
start next week to configure that.
just for remained - my router is in mgcp protocol .there is a way to operate the e/m card in that status?
thanks sharon
07-25-2018 09:24 AM
07-25-2018 10:25 AM
I do what to register it with mgcp.
in Srst mode. the phones (sip,sccp) that register to the srst can dial to the e/ m.
I look for configuration docs but can not fine. some doc says that it cannot works.
can you point me to docs that help with configuration?
07-25-2018 10:38 AM
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide