07-13-2010 04:31 PM - edited 03-19-2019 01:15 AM
Hi,
I have a new install of h323 gateway with CUCM 7.X. I am testing with only one FXO voice port 0/3/0. Inbound calls work, but I cannot get outbound to work and CUCM is sending the correct digits to the H323 GW and it is matching the dial-peer. Number called was 92345966 from ext 1002
I have attached the relevant portions of the config, with a debug voip ccaip inout
what am i missing
Cheers
Nki
07-15-2010 06:16 AM
Hi Nki
Your configuration seems to be ok. Can you tell me the end to end call flow from which phone (1002) are you making the call and where
are you terminating 92345966 (mention type of phone) involving all the H.323 Gw IPs ?
Also give me debug voip ccapi inout for one call.. based on you debug output i can see the call is landing on the dial-peer but
failed to reach the destination number 92.... could be a parameter setting based on the end device.
07-16-2010 05:04 AM
Hi,
My config was correct, customer was not providing a direct POTS line from Telco, but one from their legacy PBX. So I stopped stipping 9 from the pattern and allow their legacy pbx take care of that.
Cheers
Nki
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide