Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, i have configured vg204 with SCCP. The ports register in CUCM and I can connect an analog phone to make inbound and outbound calls with two way audio. A fax line connected to the same port will not receive or send faxes. when i dialout from th...
Hello I have two SIP gateways (GW1 and GW2 in this order) in a route group configured for Circular distribution algorithm. What do i need to configure to make sure that when GW1 LAN or SIP trunk to ITSP is down, outgoing call that were bound to use G...
HelloI cant auto register either SIP or SCCP device on a new cluster. I have enabled auto-registration for the subscriber and Default CCM Group. Option 150 is configured for the voice dhcp scope.Any idea why no phones will auto register?
Hi,
I re-imaged our Firepower from FTD to ASA successfully. What is the command to configure the firepower to point to the firesight management center so it can be managed. I can use the connect asa command to access the ASA, but not quite sure how...
I am running Firepower management center vmware 6.0.2.5 and i have a question on User reports. I would like to generate a user report that shows bandwidth utilization per application for that user for a specified period of time and how much time was ...
Thanks, you probably missed when i said i reimaged from FTD to ASA, so only connect ASA available as a command. I need the dynamic routing protocols available on the ASA, and that's why i changed code. So my question is with running the ASA code, doe...
