IP FAX

[fb_webuser]

Hi , i have to configure IP fax to IP fax via ATA , is there anyone who can help me with the required steps to follow

---

Posted by WebUser Rodolph Kassouf from Cisco Support Community App

[kamal gargoum]

i think  it is like you configure new phone just add the ATA from the add new device tap in the call manager and redirect the call from the outside line to the internal number of the ATA

[Chris Deren]

Have you tried googling for it, there are plenty of examples, here are couple:

http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_configuration_example09186a00800c3a50.shtml

http://www.cisco.com/en/US/products/hw/gatecont/ps514/products_configuration_example09186a00800a892f.shtml

Chris

[fb_webuser]

Cedren: i configured the ata in call manager and its status is registered and both the faxes on each ata is reachable. when i try to send fax form one machine to another machine it give dial tone and status struck on connecting i.e it dont transfer the paper. note this fax is connected on LAN only

---

Posted by WebUser Rodolph Kassouf from Cisco Support Community App

[Chris Deren]

Did you assign proper CSS to the device, i.e. can you connect analog phone to see if you can make a call between the devices? What fax prorocol are you using?

Chris