cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1387
Views
0
Helpful
2
Replies

Jump Upgrade and CUC 7.1.5 to 9.x

Im am performing a jump ugrade in couple of weeks from CUCM 7.1.5 to 9.x and CUC 7.1.5 to 9.x.

I was going over the steps for CUCM and the last step is to Rebuild the virtual machines to align disk partitions.

Because CUCM prior to 8.0 (2) are not supported on VM the partitions need to aligned

 

However, I went over the steps for CUC and i dont see any mention of having to Rebuild the Virtual Machine.

 

Is the VM Rebuild only necessary for CUCM and not CUC ?

 

Thanks

 

JP

1 Accepted Solution

Accepted Solutions

Jaime Valencia
Cisco Employee
Cisco Employee

First of all, the jump upgrade procedure is ONLY supported for CUCM, no other product.

For CUC, you either follow the old path (upgrade on MCS to an ESXi compatible version so you DRS from MCS to UCS), or use COBRAS.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

View solution in original post

2 Replies 2

Jaime Valencia
Cisco Employee
Cisco Employee

First of all, the jump upgrade procedure is ONLY supported for CUCM, no other product.

For CUC, you either follow the old path (upgrade on MCS to an ESXi compatible version so you DRS from MCS to UCS), or use COBRAS.

HTH

java

if this helps, please rate

www.cisco.com/go/pdihelpdesk

HTH

java

if this helps, please rate

Thank you

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: