Mapping CDRs to SIP Trunks

[Vadym Khalimovskiy]

Hi folks!

 Does anybody known how to map the CDR's to the corresponding SIP Trunk ?
I'm getting the data from CDR and need to map the call to the certain SIP Trunk which this call passed through. AFAIK there is only "origDeviceName"/"destDeviceName" fields in CDR which can be used for looking the appropriate SIP Trunk.

Best regards,
Vadym.

[devils_advocate]

The CDR will be mapped to whichever SIP trunk it came in on or went out of surely?

If I look at one of our CDR records, the IP address of our primary gateway is listed as this is where the calls route in and out of.

Perhaps I am misunderstanding what you are asking?

[Vadym Khalimovskiy · Accepted solution]

  I don't need the  IP address because it can be any count of SIP Trunks related to the gateway, so IP just tell nothing. The question was about the defining of the SIP Trunk (from a CDR info) for a particular call.

In fact, that two above-mentioned fields seem to be enough to define the SIP trunk for a particular call via its CDR.