UCCE 11.5 with CUCM Jtapi GW bandwith requirement.

[art.vazquez]

Hello

I have to provide information of how much bandwidth would consume a link between the UCCE PG with the JTAPI GW to the CUCM server.

I have checked all the 11.5 Solution Guide Design but couldn't find any info about that point.

Has any one any experience of how to calculate it based on ip phones, CTI routepoints etc that will be used by Rogger?

Any help will be appreciated.

Best Regards

Arturo Vazquez

[Sasikumar Divvela]

I see the below statement in the 11.5 design guide.

Bandwidth, Latency, and QoS for Unified CM

Bandwidth for Agent Phones to Unified CM Cluster

The required bandwidth for phone-to-Unified CM signaling is 150 bps for each phone.

For example, in a 1000 agent solution, each contact center site requires approximately 150 kbps.

And i believe the bandwidth between the PG and CUCM includes calls as well. and there is an example given in the doc "Example Calculation for a Combined Dedicated Private Link" section. 

Check if it helps.