10-07-2014 05:25 PM - edited 03-20-2019 06:09 AM
Hi all
I'm trying to restore a backup from unity connection 8.6 to a fresh install platform but the database item fails every time at 50% or 60%, all the parameters, software version, and the license mac are the same, Any ideas what happened?
Thanks a lot.
10-08-2014 01:24 AM
One possible reason could be if there is a mismatch in the DNS config on the original cluster and the one on which the backup is being restored. Please ensure that DNS lookups are working on the new cluster. Else upload the DRS restore traces to see what could be going wrong.
HTH
Manish
10-08-2014 04:00 PM
Hi
The configurations is exactly the same, the licence mac is the same in both servers, tomorrow im going to upload the traces from drs with new fresh installation because when the drs fails the database restoration and shows the error and then the virtual machine is completely corrupted.
10-08-2014 06:44 AM
May be backup file has been corrupted, try to take a new backup and restore to a New System.
regards
Ram
10-08-2014 03:54 PM
Hi
I made diferentes backups and the result was the same, any other idea?
01-05-2016 04:22 PM
Hi,
i have the same issue .
Do you find a solution ?
Thanks,
My error :
----> BEGIN Standard Error
bad decrypt
17306:error:06065064:digital envelope routines:EVP_DecryptFinal_ex:bad decrypt:evp_enc.c:330:
Wed Jan 06 01:20:08 CET 2016:main:connect() SQLException
Wed Jan 06 01:20:08 CET 2016:main:
Wed Jan 06 01:20:08 CET 2016:main:handleConnectionException: ErrorCode is -908
No processnode record
Wed Jan 06 01:20:08 CET 2016:main:connect() SQLException
Wed Jan 06 01:20:08 CET 2016:main:
Wed Jan 06 01:20:08 CET 2016:main:handleConnectionException: ErrorCode is -908
No processnode record
Traceback (most recent call last):
File "/usr/local/cm/bin/do_restore.py", line 159, in ?
nodes = len(dbllib.getProcessNodeList(''))
File "/usr/local/cm/lib/dbllib.py", line 736, in getProcessNodeList
raise Exception, "Cannot get processnode list"
Exception: Cannot get processnode list
01-06-2016 05:18 AM
Hi
You have to make sure your cucm has reachability to dns, default gateway and NTP and the values has the same information like host, ip, mask, etc, in my case was the solution.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: