Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
INSTALL LICENSE ON CSR 1000v ( for security license, other license also same method)====================================
Step 1: copy the license file to CSR1000vStep 2: Install the license
Router#license install bootflash:9XXXXXX_XXXXXXXX.licRouter#...
Hi ,Recently i am facing issue in decoding the Skinny Messages on wireshark traces. Since wireshark can't able to see the SKINNY messages the RTP streams are not properly decoded and my recording server failed to record the calls. The phone model tha...
Hi ,Recently i am facing issue in decoding the Skinny Messages on wireshark traces. Since wireshark can't able to see the SKINNY messages the RTP streams are not properly decoded and my recording server failed to record the calls. The phone model tha...
Hi, You can use Policy based routing (PBR) on Core SW at Main Site, where you can match the source (server0) and destination(any or 0.0.0.0/0) and route the traffic to FW02.
Hi Pedro, The basic prerequisite to form the Etherchannel is "All interfaces in each EtherChannel must be the same speed" . As far as i know , you can't mix different link speeds to create a portchannel. http://www.cisco.com/c/en/us/support/docs/lan-...
Hi,use command "show power inline " and check the used/remaining power. Power will be provided based on the PoE devices capability & vary depend on the Phone model. Use Cisco Power calculator tool to know how much power can be provided/support by you...
