Good morning
Company is using UC520-24U-4BRI-K9.
There is a need to terminate 2 ISDN BRI circuits (2-wire circuits), provided by the TEL COM provider, to UC520.
TEL COM PROVIDER, terminates each one of those 2 circuits to 2 Network Termination devices.
(Please for information regarding the topology
refer to UC520_CONNECTION TEL PROVIDER.pdf attached diagram).
So the available ISDN interface is S Interface (as shown in diagram).
Here are my questions:
- Can I terminate each one of those 4 – wire circuits (ISDN S Interfaces) to the 2 out of 4 BRI ports of the UC520?
If so, could you please me provide me with guidance regarding configuration?
2. Otherwise, which one of the VIC2-2FXO or VIC2-2BRI-NT/TE should I install in the UC520? Any configuration guidance?
Thank you very much for your time.