cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
590
Views
0
Helpful
2
Replies

B200 M3 - Adapter Firmware recovery

Richard Simmons
Level 3
Level 3

Hi,

I have been downgrading the firmware on some B200 M3 servers to match the rest of the estate, one of the blades in Chassis 4 had an issue during the process and now the Adapter is showing no firmware and a critical fault on the sever. I have tried decommissioning the Chassis and the server but the issue persists and i don't know how to recover the Adapter firmware or if its even possible?

Is there a way to fix this or does it need to be replaced?

Thanks,

Richard

1 Accepted Solution

Accepted Solutions

Kirk J
Cisco Employee
Cisco Employee

Hi Richard.

You'll want to open a TAC case and see if anything can be done aside from replacing the adapter.

Thanks,

Kirk...

View solution in original post

2 Replies 2

Kirk J
Cisco Employee
Cisco Employee

Hi Richard.

You'll want to open a TAC case and see if anything can be done aside from replacing the adapter.

Thanks,

Kirk...

Richard Simmons
Level 3
Level 3

Thanks Kirk, raised a TAC case and it required hardware replacement .

Regards,

Richard

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: