Hi,
I have the following setup
-NetApp Storage
-2 x UCS C200-M2
-Qlogic HBA 4Gbps dual port "QLE2462"
-2 x mds 9124 running 5.0(1a)
The NetApp is stable and and apparently no problems, but one port of each HBA area constantly loosing connectivity, I'm also receiving several OLS and NOS messages
SOERAD-FC-9124-01# sh int fc1/5
fc1/5 is up
Hardware is Fibre Channel, SFP is short wave laser w/o OFC (SN)
Port WWN is 20:05:00:05:73:e2:da:00
Admin port mode is F, trunk mode is on
snmp link state traps are enabled
Port mode is F, FCID is 0x100200
Port vsan is 10
Speed is 4 Gbps
Rate mode is dedicated
Transmit B2B Credit is 3
Receive B2B Credit is 16
Receive data field Size is 2112
Beacon is turned off
5 minutes input rate 448 bits/sec, 56 bytes/sec, 0 frames/sec
5 minutes output rate 600 bits/sec, 75 bytes/sec, 1 frames/sec
2437809 frames input, 3617093236 bytes
0 discards, 0 errors
0 CRC, 0 unknown class
0 too long, 0 too short
4237464 frames output, 6791197472 bytes
3 discards, 0 errors
1022 input OLS, 442 LRR, 108 NOS, 0 loop inits
562 output OLS, 608 LRR, 939 NOS, 0 loop inits
16 receive B2B credit remaining
3 transmit B2B credit remaining
3 low priority transmit B2B credit remaining
Interface last changed at Wed Jun 27 04:06:58 2012
And this keep's increasing....
I have replaced the Patch and nothing, could this be a firmware problem ? I have looked also at bug navigator and nothing close to this....
Should I consider a FW upgrade ? currently I'm running c200.1.3.2.0
Kind regards,
Bruno Fernandes
