cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
205
Views
1
Helpful
1
Replies

C220 M4 Physical NICs not showing

kamalia
Community Member

Hi Everyone,

I have a C220 M4 that was previously connected to UCS and is now being used as a standalone server.

CIMC is configured and accessible via KVM. Two Ethernet cables are connected and show up in CIMC under External Interfaces.

Screenshot 2025-05-26 at 7.22.32 PM.png

However, the OS only shows vNICs — the physical interfaces aren’t detected.

Any ideas?

1 Reply 1

What do you have in the vNIC tab of the CIMC? I don't think the physical NIC;s are exposed to the OS. You might also need to use HUU to update all the firmware depending on the version. Have you tried resetting the MLOM settings to default?

Review Cisco Networking for a $25 gift card

Review Cisco Networking for a $25 gift card