C220 M5 - BMC_WATCHDOG

[RyoWon Lee]

Hello.

I am using C220 M5 and the following log occurred and it restarted.

'BMC_WATCHDOG: Watchdog sensor, Hard reset, Hard reset'

I am using version 4.1(3C).
Has anyone experienced the same case or taken action?

[Mark Elsen · Accepted solution]

  - Check if anything useful can be found in : https://bst.cloudapps.cisco.com/bugsearch?pf=prdNm&kw=BMC_WATCHDOG&bt=custV&sb=anfr

 M.

[Steven Tardy]

There are many varied causes for a BMC watchdog. Many of which have been identified and resolved (ex: CSCvv79912).

4.1(3c) firmware is from May 2021. Please upgrade to the latest firmware and monitor to see if this issue stops happening.

[abdullahmurry0011]

Hello,

It sounds like you're encountering a watchdog timer reset issue with your C220 M5. The log message "BMC_WATCHDOG: Watchdog sensor, Hard reset, Hard reset" indicates that the system watchdog timer triggered a hard reset.

This could be due to a variety of factors, such as firmware issues, hardware faults, or configuration problems. Here are a few steps you might consider:

1. Update Firmware: Ensure you are using the latest firmware version. Sometimes, firmware updates resolve known issues.
2. Check Hardware: Inspect the hardware components for any signs of failure or overheating.
3. Review Logs: Look at other system logs around the same time for additional clues.
4. Consult Documentation: Refer to the manufacturer's documentation for any specific recommendations related to watchdog timer resets.

If the problem persists, you might want to contact Cisco support for further assistance.

[Mark Elsen]

@abdullahmurry0011  And this reply could be due to AI....