C220M4 CMOS password
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-07-2025 07:53 PM
The CMOS password for the C220 M4 is set, even though I did not configure it myself.
I also executed the clear-cmos
command, but the password is still present.
When I press <F6>
, it prompts me to enter a password, as shown on the screen.
What is the default password?
- Labels:
-
Unified Computing System (UCS)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-07-2025 10:32 PM - edited 01-07-2025 10:35 PM
Hello JIN3,
The default password for the Cisco UCS C220 M4 server's BIOS Administrator is not specified in the available documentation. Here are the recomendations:
- The default user account for the Cisco UCS server is admin.
- There is no default password for the admin account, if didn't work try password as password
Best regards
******* If This Helps, Please Rate *******
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
01-08-2025 08:05 AM
Cisco UCS C220 M4 Server Installation and Service Guide has a section:
Using the Clear Password DIP Switch detailing the process.
Figure 3-34 Service DIP Switches (SW6) shows an image indicating where these are physically located.
