CIMC not accessible after NIC Interface change

[marcelh]

I accidentally saved a configuration change while logged into the CIMC GUI for the NIC Properties.

The NIC Mode is set to Shared LOM and I didn't notice that the NIC Interface was changed from Console to GE1 until I had already pressed the Save Changes button. The CIMC is now no longer reachable from the configured IP address (ping, SSH, HTTP, etc.).

Is there a way to change this back to Console without being able to access the CIMC?

[Kirk J]

Take a look at https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/e/gs/guide/b_Getting_Started_Guide/b_3_x_Getting_Started_Guide_chapter_0100.html#concept_F3939C44791A4A92AD734FCD782237D4 and see if you can reconfigure the CIMC from the router device itself...

Kirk...