Configuration Guide for 6248 and 5548 and VNX 5500

[Amit Vyas]

Hi,

Need help here to configure the FCoE Uplink + Ethernet Uplink in Port channel

Following is the connectivity details from 6248, 5548 and VNX5500.

I have configured Port Channel in following way on Both Fabric Interconnect

After Configuring above things I am getting following Faults on Servers

For NetApp3240 ENM source pinning failed, I have allowed VLAN ID 21 in Uplink manager then too this Link state is  not showing UP and Same thing go for both FC_vHBA

Kinldy help me to configure the setup

-Amit

[Amit Vyas]

Thanks a lot Padma for your help till now

Your last comment done the trick here.. I made changes at FI level which you suggested i.e. single port channel interface have 6 interfaces and "vpc" on N5K came up as expected

Also want to know that can we do FCoE vPC between 6248 & N5K ?

Thanks once again

-amit

[padramas]

FCoE over vPC (  FI <--  vPC+FCoE --> N5K )  is not supported.

[sbhadrav@cisco.com]

Is it FCoE end to end or FC between N5K and VNX ?

UCSM 2.1 is required for FCoE uplink from FI.

Sample configuration is available here

https://supportforums.cisco.com/thread/2205748?tstart=30

If it is FCoE towards VNX, configuration would be similar as above. If not, you can refer to following guide for FC interface configuartion.

http://www.cisco.com/en/US/products/ps9670/products_installation_and_configuration_guides_list.html