Convert FlexFlash from non RAID to RAID1

[JerinLeonard]

All,

Is there a method for converting an existing single card flex flash to RAID 1 without losing data on the existing flexflash card.

Blades were originally purchased and configured with a single FlexFlash SD card.  Now there is a desire to add an additional FlexFlash SD card and configure them as RAID 1.  Operating System has already been installed at this point.

b200 M4's

Local disk configuration policy = "Any config"

[Kirk J]

Greetings.

Checking https://www.cisco.com/c/en/us/products/collateral/servers-unified-computing/ucs-c-series-rack-servers/whitepaper-c11-734876.html#_Toc459341671

you should be able to insert the additional card, enable autosync, and reference the admin card slot as the one with the current data that will be used as the mirror source.

Thanks,

Kirk...