01-25-2018 10:49 AM - edited 03-04-2019 02:27 AM
Our have configered FI to Nexus with NSX. it's mode Port-Channel mode.
Asking to balacing algorithm about following mode, what is a default mode ?
Solved! Go to Solution.
01-25-2018 10:57 AM - edited 04-25-2018 05:22 AM
You can run this command to check. Below outputs should be default on this code train:
FI-A(nxos)# show port-channel load-balance
Port Channel Load-Balancing Configuration:
System: source-dest-ip
Port Channel Load-Balancing Addresses Used Per-Protocol:
Non-IP: source-dest-mac
IP: source-dest-ip source-dest-mac
FI-A(nxos)# show version
<snip>
Software
BIOS: version 3.6.0
loader: version N/A
kickstart: version 5.0(3)N2(3.13b)
system: version 5.0(3)N2(3.13b)
01-25-2018 10:57 AM - edited 04-25-2018 05:22 AM
You can run this command to check. Below outputs should be default on this code train:
FI-A(nxos)# show port-channel load-balance
Port Channel Load-Balancing Configuration:
System: source-dest-ip
Port Channel Load-Balancing Addresses Used Per-Protocol:
Non-IP: source-dest-mac
IP: source-dest-ip source-dest-mac
FI-A(nxos)# show version
<snip>
Software
BIOS: version 3.6.0
loader: version N/A
kickstart: version 5.0(3)N2(3.13b)
system: version 5.0(3)N2(3.13b)
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide