Hey all,
Upgraded my system to 2.1 yesterday. Lost connectovity to the SAN. I see that my FC trunks are in a failed state. My upstream devices are a pair of MDS 9124 running code 4.1(3a).
Here is the config that was woring on my switch before the upgrade. Also note that I had a lot of trouble getting this to work with 2.0 and without doing anything it sudenly started working. It likely would have failed if I had just restarted at the old 2.0.4 version.
interface port-channel 1
channel mode active
switchport rate-mode dedicated
switchport trunk mode off
interface fc1/23
switchport description CAPH-UCS1
switchport trunk mode off
port-license acquire
channel-group 1 force
no shutdown
interface fc1/24
switchport description CAPH-UCS1
switchport trunk mode off
port-license acquire
channel-group 1 force
no shutdown
UCS is running 2.1 and is in end-host mode.
Thanks,
Patrick