cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
681
Views
5
Helpful
2
Replies

How to add a VLAN to a B200 M3

ggunselm1
Level 1
Level 1

I have a UCS B200 M3 that is a Veeam Proxy server and I need to give it access to an additional VLAN.

There are several other blades with access to the VLAN and I can see it.

UCS Manager is 3.1(h)

Thanks for any clues,

Glen

(I apologize if I posted this in the wrong place.)

1 Accepted Solution

Accepted Solutions

Wes Austin
Cisco Employee
Cisco Employee

Glen,

You will need to add that VLAN to the vNIC on the service profile of the blade in question.

If the vNIC is created from an updating template, you will need to add the VLAN to the updating vNIC template OR unbind the vNIC from the template and make the necessary changes.

Servers Tab > Service Profile > vNIC

LAN Tab > Policies > vNIC Template

HTH,

Wes

View solution in original post

2 Replies 2

Wes Austin
Cisco Employee
Cisco Employee

Glen,

You will need to add that VLAN to the vNIC on the service profile of the blade in question.

If the vNIC is created from an updating template, you will need to add the VLAN to the updating vNIC template OR unbind the vNIC from the template and make the necessary changes.

Servers Tab > Service Profile > vNIC

LAN Tab > Policies > vNIC Template

HTH,

Wes

That was the clue I needed.

Thanks,

Glen

Review Cisco Networking for a $25 gift card

Review Cisco Networking for a $25 gift card