
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-18-2014 09:30 PM - edited 03-01-2019 11:50 AM
hi
how do I change the queue depth for an esxi host in 5.1 for ucs b200?
In esxi
I type esxcli system module parameters -m list
it shows
Solved! Go to Solution.
- Labels:
-
Unified Computing System (UCS)
Accepted Solutions

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-18-2014 10:36 PM
Has been covered before, see e.g.
https://supportforums.cisco.com/discussion/12215126/queue-depth-execution-throttle
https://supportforums.cisco.com/discussion/11744776/ucs-hba-queue-depth-vmware-esxi-51

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-18-2014 10:36 PM
Has been covered before, see e.g.
https://supportforums.cisco.com/discussion/12215126/queue-depth-execution-throttle
https://supportforums.cisco.com/discussion/11744776/ucs-hba-queue-depth-vmware-esxi-51

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-19-2014 06:14 PM
hi
does it require a reboot for this?

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
09-20-2014 08:39 AM
is it recommeded to change the queue depth to 128 or higher? what is the best practice? default is 32 for esxi 5.1
