Buy or Renew
Buy or Renew
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
686
Views
0
Helpful
1
Replies

How to connect & config Dell PV132T in UCS?

ciscomagnet
Level 1
Level 1

‎11-02-2011 09:45 AM - edited ‎03-01-2019 10:07 AM

Hello,

I just finished the "DCUCI" training class.  I am not really sure how to do this.

I need to connect our Tape library Dell PowerVault 132T which connects using FC cable to our UCS system.  Previously it was connected to our CX300 FC Interconnects.

Can somebody help me with the main steps i have to follow to accomplish this?

I have 4 hosts (ESXi 4.1)

I would like to connect the PV132T to a VM inside the host.

Thank you!

Flavio

0 Helpful
1 Reply 1

Robert Burns
Cisco Employee
Cisco Employee

‎11-02-2011 09:54 AM

Flavio,

Tape Libraries are not supported for direct connect to a UCS Fabric Interconnect.  Additionally, the only supported direct connect storage devices are NetApp & EMC at this stage.

See the UCS Hardware Support Matrix for more detail.

Regards,

Robert

0 Helpful
Customers Also Viewed These Support Documents

Review Cisco Networking for a $25 gift card

Review Cisco Networking for a $25 gift card