Experts, first I need to admit I am new to this technology.
With reference to some issue in our network I have identified I need to change the native vlan configuration for the UCS 6120 from the nxos cli.
Question is how to do this?
I have looged into the cli and see this command:
hou-rd-ucs03-6120-A(nxos)# sh run int eth1/1
!Command: show running-config interface Ethernet1/1
!Time: Thu Jul 12 06:43:32 2012
version 5.0(3)N2(2.02q)
interface Ethernet1/1
description U: Uplink
switchport mode trunk
switchport trunk native vlan 15
switchport trunk allowed vlan 1,10,15,20,25,29-32,34
spanning-tree bpduguard disable
no shutdown
hou-rd-ucs03-6120-A(nxos)#
I need to change that native vlan to 3, how do I do this?
Regards,
Nikhil