Nexus 1010 boot failed

[MENG YUAN HSIEH]

Hi all,

I tried to boot nexus 1010, but only cimc can login. The serial console did not show any information, and still no response. So I tried to connect keyboard and monitor, both are no response. In addition, the nic port is down too.

Have any idea? Or who to troubleshooting it?

Sent from Cisco Technical Support iPhone App

[padramas]

Hello Meng,

Are you able to access the CIMC via web browser ?

If yes, do you observe any error messages ?

Any output on the KVM console ?

Padma

[MENG YUAN HSIEH]

Hello Padma,

Are you able to access the CIMC via web browser ?

-> Yes.

If yes, do you observe any error messages ?

-> No! All the status is "Good".

Any output on the KVM console ?

-> No! The KVM show "No Signal".

Sent from Cisco Technical Support iPhone App

[padramas]

Hello Meng,

Has this server worked before ?

Are you able to access the N1010 host CLI interface by doing SSH to CIMC IP address ?

ssh admin@

connect host

Padma

[MENG YUAN HSIEH]

Hello Padma,

Has this server worked before ?

-> Yes.

Are you able to access the N1010 host CLI interface by doing SSH to CIMC IP address ?

-> Yes.

ssh admin@ "connect host" did not show any response, and console can not return to CIMC.

Sent from Cisco Technical Support iPhone App

[Yasemin Akar]

When you reboot N1010 from the KVM console, do you see any output?

[MENG YUAN HSIEH]

Hi Yasemin,

After few day later. We used front panel port to connect monitor and keyboard, mouse and reboot it. It is work. But the back of the monitor port still did not work. BTW, the system can work now.