Hi Guys,
I have a Cisco C210M2 server connected to the nexus switch directly. 2 ports are configured for port channeling and vpc.
On the Server I installed ESXi and created a vSwitch and a host with an IP of 192.168.90.210
I have a storage connected to the pair of Nx switch and configured for PC and vPC. On the storage I have configured the IP on the same range
192.168.90.200
I was not able to ping between the IP address. I have checked that the portchannel is up and runing and vPC status shows as up.
Baically not a networkin guy, I googled a lot and came across lldp.
If I did a sh lldp entry , I can see the storge ports there not the server ports.
On the sh lldp dcbx interface eth1/xx I cannot see any peer information , where as on the other ports I can see the peer information.
The server ports are 1G ports and I configured the speed to 1000 on the nexus , where as the storage ports and 10G.
Any help wil be appreciated, I can provide more details if required.
George