06-19-2015 08:50 AM - edited 03-01-2019 12:14 PM
I have a UCS B200 blade/chassis with Cisco Virtual Interface Card 1240. I cannot for the life of me get NPIV to work. I can't find any configuration documents for this setup and the only post on here I found is from 2 years ago and says that Cisco mezzanine cards do not support NPIV. Can this still be the case today?
vmkernel log attached.
Solved! Go to Solution.
06-20-2015 02:14 AM
Last time I was checking (late 2014) there was no plan for NPIV on ESX hosts.
We've got it running and documented for Hyper-V.
Best to reach out to your local SE ... there seems to be some demand for this feature.
06-20-2015 02:14 AM
Last time I was checking (late 2014) there was no plan for NPIV on ESX hosts.
We've got it running and documented for Hyper-V.
Best to reach out to your local SE ... there seems to be some demand for this feature.
06-20-2015 08:05 AM
Thanks for the reply. I finally did enough digging to find a footnote sitting at the bottom of the release notes saying it's not supported. The feature is actually a pain to configure so if it weren't for a specific use case we have I wouldn't even bother.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide