portchannle in UCS any idea about the solution

[mabuhantash]

we create a Portchannel in the UCS but it show up in the switch and in the UCS show failed

since no operatioma member f0727 with this error ??

<faultInst

ack="no"

cause="membership-down"

changeSet=""

code="F0727"

created="2012-01-30T10:25:46"

descr="lan Member 1/19 of Port-Channel 10 on fabric interconnect B is down, membership: individual"

dn="fabric/lan/B/pc-10/ep-slot-1-port-19/fault-F0727"

highestSeverity="major"

id="41644"

lastTransition="2012-01-30T10:25:46"

lc=""

occur="1"

origSeverity="major"

prevSeverity="major"

rule="fabric-eth-lan-pc-ep-down"

severity="major"

status="created"

tags="network,server"

type="network">

</faultInst>

[Robert Burns]

Mohammed,

There appears to be an issue with the Port Channel negociation.  UCS FI intefaces can only negociate LACP Port channels, so ensure your upstream switch supports and is configured for LACP (802.3ad). 

Once you double check/fix this, disable the Port Channel and then re-enable it. 

If you're unsure, post the interface configuration of the upstream switch(es).

Regards,

Robert

[mabuhantash]

I think they use the nonegotiation mode in the upstream switch it not supported ??

[Robert Burns · Accepted solution]

No.  LACP is the only channeling option.

Regards,

Robert

[mabuhantash]

becuase of that the portchannel in the upstream switch shows SU

I will try to give you the configuration withen 3 hours from now thanks

[mabuhantash]

thaks

also I saw an issue in the chassis 1 as major post faluire error I think due to fan error is that possible