- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-05-2023 04:37 PM
I have formatted and installed new firmware on a UCS Fabric Interconnect 6324.
Whenever the system is power cycled, I get the
loader>
prompt and have to manually issue the boot command for the kickstart image.
How can I configure the system to automatically load the kickstart image and then the system image?
Thanks in advance
Solved! Go to Solution.
- Labels:
-
Other Switches
-
Other Switching
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-07-2023 05:11 PM
Did you rebuild the FI manually?
Have you tried to "Activate" the firmware in the "Installed Firmware" tab? That is typically the resolution for your scenario. In this "Installed Firmware" tab, this scenario would show a "Running-Version" value in its respective column, and the "Startup Version" column would be empty.
Let me know if this works for you.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-06-2023 01:24 AM
- Check this article : http://terenceluk.blogspot.com/2015/06/recovering-cisco-ucs-fabric.html
M.
-- Each morning when I wake up and look into the mirror I always say ' Why am I so brilliant ? '
When the mirror will then always repond to me with ' The only thing that exceeds your brilliance is your beauty! '
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-07-2023 05:11 PM
Did you rebuild the FI manually?
Have you tried to "Activate" the firmware in the "Installed Firmware" tab? That is typically the resolution for your scenario. In this "Installed Firmware" tab, this scenario would show a "Running-Version" value in its respective column, and the "Startup Version" column would be empty.
Let me know if this works for you.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
03-21-2023 11:02 PM
Thank you, this worked for me
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-27-2024 08:24 AM
how to install operating system in Cisco UCS FI-M-6324? I have just bought 2 of them but they are password protected and have no operating system show in loader mode to break the password.
